General Questions

Ask a Question

Use the form below to ask a question

Fill in your email address

Displaying 61 - 70 of 701234

My thread starts winding around the thread holder instead of staying on the spool and then the tension gets so tight the thread breaks. What is the average tension setting on a janome machine,higher or lower number?

Please fill in an answer

I bought this product some time ago from a Nancy's Notions catalog. I found it in a drawer and thought I would try it. The instructions were not clear at all. I could not tell what part was what. When I tried to push the little round thing onto the rod, it broke. I don't remember what I paid for this product, but I would not recommend this to any sewer!

Please fill in an answer

I purchased the Specialty Thread Spool Pin Adapter in Paducah, Ky. It will not work on my machine. I have a Janome Skyline S5. I have to keep the top opened to attach it to the bobbin holder and the Top of the machine is in the way. I would like to return the adapter for a full refund.

Please fill in an answer

Hi, I just received the Thread Director. My Spool cap does not slide over The Director. It is too tight. I am mounting The Director on Bobbin Winder. Please advise, Regards, Patricia Ng ngpat62@yahoo.com

Please fill in an answer

Can the thread director be used for embroidering with metallic embroidery thread; does it fit the embroidery spools?

Please fill in an answer

Hi. Can this product be used with a Brother SE1800?

Please fill in an answer

Where can I buy spool caps? I''ve managed to lose one of the small caps?.

Please fill in an answer

with the thread director 2, do you have to use 2 spools? I'm thinking just one will work. Just double checking...

Please fill in an answer

Does the thread director fit the bobbin on the Pfaff Creative 4.5 and/or Pfaff Creative 1473?

Please fill in an answer

Do you wholesale? I am a brick and mortar shop. Thanks

Please fill in an answer

Displaying 61 - 70 of 701234